Some interested things to do with Maximo to improve your work using it.
The course is a group of tips which I collected and developed during 15 years of work with Maximo starting with ver. 3.1 up to ver. 7.6.
What you’ll learn
- Improve the using of Maximo (from ver. 5.2 to 7.6).
- Create personal tool for you to easy use Maximo.
- Design preventive Maintenance routine using time base frequency.
- Design preventive Maintenance routine using meters reading base frequency.
Course Content
- Introduction –> 1 lecture • 2min.
- New Maximo Personal Tool –> 2 lectures • 12min.
- Searching Master Keys on Maximo –> 1 lecture • 7min.
- Editing failure reports –> 1 lecture • 10min.
- Dynamic Job plans –> 3 lectures • 9min.
- Sequenced Job plan –> 1 lecture • 18min.
Requirements
The course is a group of tips which I collected and developed during 15 years of work with Maximo starting with ver. 3.1 up to ver. 7.6.
I starting work as planning engineer on Maximo department up to be a department head of it. I developed an electronic system to edit GL account of financial department and the administrator build it into Maximo. I’m also design a lot of application on my company using my experience on programming using Visual Basic dot net platform.
The latest developing tool from my creation is the Maximo Personal tool to open maximo easily. You just entering the password once and use the Personal tool all the day without entering the password again.
The contains the must common Maximo application such as (Work order – PM – Labor – Location – PR – PO – Start Center) and you can use the last one to open any other Maximo application.
You can close the Personal tool by using the [Exit] icon.
You will find a good practical lessons on the course covered all types of work.
The details will be attached with the lectures if needed and the examples also.
Hope you enjoy with this tips and I welcome with any additional tips to help users of Maximo around the world.